12/2/2023 0 Comments Tool quality extension grabberSome users carry them on their shoulders to avoid the discomfort on their hands. Okay, so installation and removal is easy, but is the Ladder Grabber actually useful? When you take hold of a ladder to pick it up, you typically will wrap your fingers around the frame where the weight will begin to dig into them. Even though it’s possible to have an issue like that, if you’ve got three solid points that the Ladder Grabber is locked into, it will hold it securely. This is a very minor issue that can be resolved by simply making the tool an inch longer. It wasn’t that big of a deal since we were still within an inch of the balance point, but I could tell that the balance was slightly off when carrying it. Also, the spreader attachment hardware is more substantial so we couldn’t install the Ladder Grabber directly on the balance point. Because of that, the side rails were thicker than most so the EXT was the only model of the two that fit. The ladder we used is more ruggedly built that most. There were a couple of issues that we ran into with installation during our testing. While it’s in no danger of coming off, it may scratch the frame. One note on that though: if you swing the ladder up into position using the Ladder Grabber, it can slide slightly. These springs are pretty high tension and do a good job of keeping the unit secure. When the Ladder Grabber is installed, the springs work with the hooks to hold it in place. It would be no problem to remove and re-install the Ladder Grabber in well under a minute. Pull the unit back and down to release the opposite side and you’re good to go. Again apply downward force and swing the hinge out away from the frame to release it. If you need to switch the handles between ladders, you’ll need to take it off. It’s perfectly reasonable to leave the Ladder Grabber on a ladder rather than removing it when you’re done. This is because is made removing the Ladder Grabber easier. I definitely preferred the hinge of the EXT over the single piece construction of the AFF model. The Ladder Grabber EXT will require an extra hand to work the hinged side. Hook one end in on the frame of your ladder and then simply apply downward force to snap it into place. Installing either Ladder Grabber model is a snap… literally.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |